Detoxio Essential installation

Step 1

Identify the SUID of the Detoxio on the back of the device.

The list of SUIDs and their assignment is available in Serenicity Control from the Reseller stock page.

Step 2

The client does not exist

Create the client from the device fleet page of Serenicity Control.

Select a reseller
Click on Create a client
Fill in the client information
Check the box Create automatically the site and the Detoxio
Enter the public IP address of the client and the SUID of the box

The client already exists

Navigate to the client from the device fleet page of Serenicity Control.

Click on Create a site
Fill in the site information

After saving, you will be automatically redirected to the site page:

Click on Create a device
Fill in the device information

This information can be changed at any time.

Step 3

Connect the cable from the LAN interface of the firewall / router / box to one of the two Ethernet ports (LAN1 or LAN2).

Step 4

Connect the cable from the switch / equipment / WiFi terminal to the second Ethernet port.

Step 5

Connect the power supply. If the equipment was powered on before it was connected to the network, restart it (short press on the power button to stop, short press to start).

Step 6

The network access is operational in less than 90 seconds after the equipment starts up. You can identify it on the local network thanks to its MAC address, which can be in the following formats:

00:90:xx…
88:EE:xx…
5E:DF:xx...
D2:25:xx...
32:05:xx...

Step 7

The technical contact of your reseller's form automatically receives an initialization e-mail from Detoxio a few minutes after its connection. This e-mail validates the configuration in Serenicity Control and the communication with the API.

Step 8

Detoxio automatically downloads its resources and starts its update. This operation can take up to 30 minutes, please do not disconnect the equipment during the operation.